Wideband calibration for 12P and 11P
-
- Posts: 1833
- Joined: Sat Aug 06, 2011 7:58 am
- cars: V8 VR Commodore BT1
LB Lancer 2L turbo & Delco
Starion TBI with Delco
Mitsubishi Lancer EVO4 track car
NA MX5
3 vintage motor bikes - Location: Padstow NSW
Wideband calibration for 12P and 11P
I was doing some logging today and I thought my wideband was spot-on. I noticed it's not. The logger was displaying a different reading to my Innovate wideband but not all the time. Is there a reason for this or do I need to adjust something? I have calibrated the wideband as per the manufacturers recommended procedure.
Re: Wideband calibration for 12P and 11P
Wideband 0 5 volt scalers might need adjusting.
- vlad01
- Posts: 7801
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: Wideband calibration for 12P and 11P
There is a pull-up resistor too that can be removed to fix the offset. But I just use the 0v and 5v scalars to correct it within the resolution of the ecu ADC.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.