Hello
Just wondering if it would be possible (and what I would need to do) to use a boost solenoid to control boost levels?
I am using $11p and 3bar map to run a Vk with a turbo ecotec/4l60e on e85.
I did notice a flexible output folder but have no idea on changing code
Cheers
Using $11p to control boost solenoid
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Using $11p to control boost solenoid
have a look at the tuning guides in my signature below, they should provide you the info you need on flex tables.
No matter what the question is, the answer is always more horsepower! ![turbo :turbo:](./images/smilies/TurboSmiley.gif)
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
![turbo :turbo:](./images/smilies/TurboSmiley.gif)
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Using $11p to control boost solenoid
Thanks for that, got stuck looking in posts and forgot the how to guides.
So would I be correct to say that we can only request the duty cycle of the solenoid and not the actual boost levels? So as to be able to have ecu lower boost if motor decided to overboost for any reason
So would I be correct to say that we can only request the duty cycle of the solenoid and not the actual boost levels? So as to be able to have ecu lower boost if motor decided to overboost for any reason
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Using $11p to control boost solenoid
you could use the map sensor as an axis and set it to higher duty cycle for low map levels and lower it as it gets to your targetted level .... im not sure how well it will work but you can only try.
No matter what the question is, the answer is always more horsepower! ![turbo :turbo:](./images/smilies/TurboSmiley.gif)
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
![turbo :turbo:](./images/smilies/TurboSmiley.gif)
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread