102 - Advanced Tuning Of A Delco ECM with $12P

General Tuning Questions And Discussions
v6psi gem
Posts: 44
Joined: Sun Nov 27, 2011 8:56 pm
cars: turbo v6 gemini & v6 sierra

Re: 102 - Advanced Tuning Of A Delco ECM with $12P

Post by v6psi gem »

so much detonation, everyone is so secretive when it comes to this subject. from the little bits of info i have got from ppl about wat is being done reminded me about some of the things i had read on here.
User avatar
Jayme
Posts: 2585
Joined: Sun Mar 01, 2009 8:59 am
Location: North Coast, NSW

Re: 102 - Advanced Tuning Of A Delco ECM with $12P

Post by Jayme »

haha yeah the ecotecs have to file down the crank sensor teeth to lower the timing a bit :P
User avatar
delcowizzid
Posts: 5493
Joined: Sat Feb 28, 2009 8:38 pm
Location: Wellington NZ
Contact:

Re: 102 - Advanced Tuning Of A Delco ECM with $12P

Post by delcowizzid »

the hole sensor ring can be moved on the rear of v6 balancers.heaps of speedway guys here run the dfi without the ecu connected and set the ring to 32 degrees of timing on a timing light
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
Shitboxvs
Posts: 1
Joined: Sat Mar 21, 2020 7:37 pm
cars: Sleeper vs wagon in the making

Re: 102 - Advanced Tuning Of A Delco ECM with $12P

Post by Shitboxvs »

Hi guys im in a bind

I have a 1995 vs wagon
Gertrag

25mm plenum spacer
25mm runner spacer
255lph pump
1.9 ratio rockers
Rising rate fuel reg (50psi)
Raptor v side mount charger
35lb injectors (not fitted)

Im finding it hard to find someone to tune it
Thats not going to cost an arm and a leg
Chip torque want $2000 to tune it would anyone
Have a saved tune that i can download
And load up?
Post Reply