Hey guys
I knows its ricey lol but what settings would you adjust to get 'tail pipe' crackle on decel?
Cheers
Crackle
Re: Crackle
^ You'll also need to add some over-fuelling in the decel areas. Actually if you set it right the decel fuel cutoff can actually cause a good pop or two (but not a constant crackle) when fuel delivery starts again, apparently some of the 80s EFI Corvettes were known for this from factory.
- antus
- Site Admin
- Posts: 8251
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: Crackle
Also the "Decel Enleanment Param" tables. cut off is only the 100% fuel cut down hill, but the DE stuff is what does the partial fuel cut that stops the crackle earlier. I'd start with the two 'factors' and see what effect that can have.
- Attachments
-
- DE.png (87 KiB) Viewed 2860 times
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
- vlad01
- Posts: 7798
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: Crackle
I never touched any of the decel stuff but my daily current and previous one both crackled when in overrun with the throttle slightly open 1-2%, crackle on command basically.
I have always wondered why it does it but my other 2 cars with low K engines don't with basically the same tune.
I have always wondered why it does it but my other 2 cars with low K engines don't with basically the same tune.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.
Re: Crackle
learn something new every day...
Your Local Aussie Reverse Engineer
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726