11p transmission 4l60e holding gears
Re: 11p transmission 4l60e holding gears
That looks OK.
Mine shows 91.77, neither here or there.
You can track PWM/ TCC operation thru transmission dash.
Just connect (Acquire data) and go for a run.
That way you can see if it's being commanded.
Mine shows 91.77, neither here or there.
You can track PWM/ TCC operation thru transmission dash.
Just connect (Acquire data) and go for a run.
That way you can see if it's being commanded.
Re: 11p transmission 4l60e holding gears
quipt4it your a champion
I will lower mine to 80 and try give it a go tomorrow and watch it on the dash in tuner pro
Will let you know how i go
I will lower mine to 80 and try give it a go tomorrow and watch it on the dash in tuner pro
Will let you know how i go
Re: 11p transmission 4l60e holding gears
That's OK
The main thing to watch for is On/ Off. That figure won't help if it's not working...
The main thing to watch for is On/ Off. That figure won't help if it's not working...
Re: 11p transmission 4l60e holding gears
Another thing I thought of is temp. enable.
In the photos there are 2 flags. Maybe temporarily uncheck both, just in case of a faulty sensor/s
In the photos there are 2 flags. Maybe temporarily uncheck both, just in case of a faulty sensor/s
-
- Posts: 3426
- Joined: Thu Apr 09, 2009 12:31 pm
- cars: VH, VN, VS, VX
Re: 11p transmission 4l60e holding gears
You're talking about keeping the stock shift points of the 3800V6 motor, problem is you have a L67. I would advise the factory shift points for that as the starting point. Been that you tow a lot, you should be in power mode, that too will keep the converter unlocked and hold onto 3rd gear longer.vp304 wrote:Immortality i understand were your coming from with the older 3800 to l67 torque power differences etc.
The old 3800 is all over by 3000 rpm.
quipt4it trying to keep the trans as close to stock shifting up down as possible as its a daily drive workhorse that i use to tow a trailer here and there etc etc
Trying to avoid a race tune lolll
Can the pwm feature be turned on in 11p somewhere so my tcc works ?
Holding 3rd isn't a race tune. Off boost the L67 isn't that great, especially not in stock form. You'll find with some experimentation that staying in 3rd will actually give better economy in the L67, there is a reason Holden did this.
Re: 11p transmission 4l60e holding gears
Thanks for all the info guys will give it all a go today.
Immortality if im towing any load on the trailer i normally leave the gearstick in 3rd gear anyways
Immortality if im towing any load on the trailer i normally leave the gearstick in 3rd gear anyways
Re: 11p transmission 4l60e holding gears
You guys are champions thanks so much.
Loaded up the vt auto settings lot better. I lowered only down the 3-4th shift (under 37% tps) weird tho that my tune says to shift into 4th at 60kph but it dosnt happen to about 70kph. is it cause my down shift for that part is set higher than the upshift ? When i watched the dash in tuner pro i now remember it flicking crazy between 3rd and 4th on tuner pro dash ?
I dash checked in tuner pro and speed in tune is dead on accurate with speedo cluster kmh. The tcc is also engaging at around 80 or 90kph i think it was and is showing in tuner pro on the dash screen as coming on.
Fine tuned some of the air fuel ratios today and it is running pretty dam good all round.
Loaded up the vt auto settings lot better. I lowered only down the 3-4th shift (under 37% tps) weird tho that my tune says to shift into 4th at 60kph but it dosnt happen to about 70kph. is it cause my down shift for that part is set higher than the upshift ? When i watched the dash in tuner pro i now remember it flicking crazy between 3rd and 4th on tuner pro dash ?
I dash checked in tuner pro and speed in tune is dead on accurate with speedo cluster kmh. The tcc is also engaging at around 80 or 90kph i think it was and is showing in tuner pro on the dash screen as coming on.
Fine tuned some of the air fuel ratios today and it is running pretty dam good all round.
- Attachments
-
- Final auto settings dec 29.jpg (202.17 KiB) Viewed 2236 times
Re: 11p transmission 4l60e holding gears
Yes, you will have to lower the downshift speed to be less than the upshift speed.
This will confuse the auto no end.
Glad it's working
This will confuse the auto no end.
Glad it's working
Re: 11p transmission 4l60e holding gears
something so simple stupid me lol
Hopefully didnt do any damage (to auto) being like that done about 50km of driving street tuning in it today
Thanks mate
Hopefully didnt do any damage (to auto) being like that done about 50km of driving street tuning in it today
Thanks mate
-
- Posts: 3426
- Joined: Thu Apr 09, 2009 12:31 pm
- cars: VH, VN, VS, VX
Re: 11p transmission 4l60e holding gears
Good to hear you're making progress. It's all a learning process.