ADX Table Mod Using Tuner Pro and 12P

[POZE]

Was considering changing the VE table in the ADX to read every 100 RPM at lower RPMs and increasing the KPAs to every 5. Other than the row and column changes would any other changes be needed to the ADX to make this work?
Thanks

[VL400]

You can change the ADX to show any data you like and have the axis configured with any breakpoints, just edit the ADX and TP handles the display. Most have it setup to match the corresponding table in the XDF, can then copy data over directly as the cells match up.

[POZE]

My mistake, was wondering if changing the XDF in 12P to have increments of 100 RPM at lower speed, maybe under 2000 RPM, and also add the 5s in the KPA row 20 25 30 35 etc. Is it as easy as just changing the rows and column or is there more to it. Then match the ADX to the XDF.

[VL400]

Changing the XDF breakpoints wont work, they must match the code and table in the ECU. The table is much larger than a factory table in 12P and should give enough tuning points.

[POZE]

Thanks VL400