Seeing there is an awesome aldl listening software here, I was wondering if there's a similar thing for obd2?
I just got an elm327 1.5a & trying to listen in on process's going on when connected to pcm's
OBD2 listening software for elm327
-
- Posts: 2882
- Joined: Sun Aug 02, 2009 9:16 pm
- Location: Bayside, Melbourne, Victoria
- Contact:
-
- Posts: 1833
- Joined: Sat Aug 06, 2011 7:58 am
- cars: V8 VR Commodore BT1
LB Lancer 2L turbo & Delco
Starion TBI with Delco
Mitsubishi Lancer EVO4 track car
NA MX5
3 vintage motor bikes - Location: Padstow NSW
Re: OBD2 listening software for elm327
Mark Mansour from Tunerpro has written and ADX file for the elm327. I have used it and tried it for logging OBD2 and yes it works but I can't find it at the moment. I will have a good look tomorrow and hopefully post it here. Regards Dave
- durahax
- Posts: 34
- Joined: Sat May 12, 2012 3:00 am
- cars: 03 GMC Sierra 2500HD - LB7 Duramax Diesel
- Location: Philadelphia, PA
Re: OBD2 listening software for elm327
I think the ADX is for logging PIDs, that's a bit different. You don't really need any special software, just open a serial connection to the elm and enter a few commands. Here's what I usually do...
AT Z [reset]
AT AL [allow long messages]
AT H1 [headers on]
AT MA [monitor all]
Have fun?
Also this is the terminal I was using for logging, works on elm too - http://www.scantool.net/scantool/downlo ... tnterm.exe
AT Z [reset]
AT AL [allow long messages]
AT H1 [headers on]
AT MA [monitor all]
Have fun?
Also this is the terminal I was using for logging, works on elm too - http://www.scantool.net/scantool/downlo ... tnterm.exe
-
- Posts: 2882
- Joined: Sun Aug 02, 2009 9:16 pm
- Location: Bayside, Melbourne, Victoria
- Contact:
Re: OBD2 listening software for elm327
Thanks durahex,
That's a great starting point, sorry I knew the adx was no help should have replied!
That's a great starting point, sorry I knew the adx was no help should have replied!