Injector Flow Testing Data

by **The1** » Sat Jan 11, 2014 12:21 pm

Quick question what does everyone expect or would like to see data wise on an injector flow sheet? For example i have a dummy one attached is some of it not needed or some is?

by **antus** » Sat Jan 11, 2014 12:47 pm

That looks like the most thorough one ive seen to date :thumbup:

by **The1** » Sat Jan 11, 2014 1:46 pm

added average flow rate and resistance, variation.

by **The1** » Sat Jan 11, 2014 1:53 pm

if anyones interested also here's some photos i took of ev1 & ev6 injectors to compair spray pattern, same flow rate.

http://www.eyeit.org/Injector/EV1vsEV6/ev1vsev6.zip

by **VL400** » Sat Jan 11, 2014 3:29 pm

Looks good to me! Normally dont get much more than a flow reading for each injectors after getting them cleaned.

by **The1** » Sat Jan 11, 2014 5:10 pm

ok thanks!

by **The1** » Sat Jan 11, 2014 5:17 pm

also does everyone think the test pattern is ok, when i looked at most machines and flow test reports they weren't really done to your average driving conditions or limits.

by **vlad01** » Sat Jan 11, 2014 6:13 pm

I am more interested if they could test lag time across the voltage range.

Anyone know if there is anyone that could do those tests?

by **Holden202T** » Sat Jan 11, 2014 7:50 pm

by **Circlotron** » Sat Jan 11, 2014 8:41 pm

vlad01 wrote:I am more interested if they could test lag time across the voltage range.

How about a 3D graph L-R showing injected quantity vs pulse width and front to rear with decreasing voltage.

Injector Flow Testing Data

Injector Flow Testing Data

Re: Injector Flow Testing Data

Re: Injector Flow Testing Data

Re: Injector Flow Testing Data

Re: Injector Flow Testing Data

Re: Injector Flow Testing Data

Re: Injector Flow Testing Data

Re: Injector Flow Testing Data

Re: Injector Flow Testing Data

Re: Injector Flow Testing Data

Who is online