like to have a PCB made.
- vlad01
- Posts: 7798
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: like to have a PCB made.
So would this be better?
- Attachments
-
- diagram.jpg (50.89 KiB) Viewed 4233 times
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.
- Circlotron
- Posts: 235
- Joined: Mon Apr 25, 2011 4:12 pm
- cars: VP 5L LPG
Re: like to have a PCB made.
Looks okay to me.
Whether a 12 volt relay would pull in reliably under all conditions at 9 volts may be a concern though.
Whether a 12 volt relay would pull in reliably under all conditions at 9 volts may be a concern though.
- vlad01
- Posts: 7798
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: like to have a PCB made.
I've used less than 9v before on 12v relays with no problems. I can get one and test it on my variable power supply and see what the minimum is to switch it.
Alternatively, you reckon the relay coil and protection diode could be wired before the regulator without any issues?
Alternatively, you reckon the relay coil and protection diode could be wired before the regulator without any issues?
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.
- Circlotron
- Posts: 235
- Joined: Mon Apr 25, 2011 4:12 pm
- cars: VP 5L LPG
Re: like to have a PCB made.
Good suggestion!
Take the diode off the relay coil and put a zener across C-E of the transistor as well.
Take the diode off the relay coil and put a zener across C-E of the transistor as well.
- jenko
- Posts: 450
- Joined: Wed Jan 29, 2014 3:43 pm
- cars: hilux v6
jaguar v12
mitsubishi lancer
fj cruiser
sv 21 camry wagon - Location: Pine mountain .vic
- Contact:
Re: like to have a PCB made.
Bosch 0 332 019 150 12v 30a relay n/o switches closed at 3.5 v and back open at 2.7 v (tested 4 of them )
- vlad01
- Posts: 7798
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: like to have a PCB made.
I just tested a micro relay 12v one from jaycar with a flat 9v battery and works just fine. Very strong click I might add.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.