Altronics high energy ignition kit module

Information and discussion of EFI hardware and specifications
User avatar
Gareth
Posts: 2505
Joined: Fri Mar 14, 2014 8:37 pm
Location: Bacchus Marsh, Vic

Re: Altronics high energy ignition kit module

Post by Gareth »

Ref input & ref low are crank & cam signals (needed for engine speed and position by ecu)

EST output = electronic spark timing (the ecu controlls the timing in accordance with engine speed)

Bypass control = sets the timing at base value so as it can be checked/set (diagnostic mode)

Hope that helps.
Last edited by Gareth on Mon Jan 04, 2016 12:26 pm, edited 1 time in total.
According to chemistry, alcohol is a solution...
vn_ss_cm
Posts: 82
Joined: Sun Jul 14, 2013 7:05 am
cars: VN SS
Location: PERTH

Re: Altronics high energy ignition kit module

Post by vn_ss_cm »

Hey Dylan I used the orginal - coil wire to trigger the altronics module...you can adjust spark and frequency with this little unit.. only issue I have is when you go to
start the car it will just crank but if you crank it and then stop and crank again it starts.
Post Reply