I'm wanting to set up water injection on my turbo crossflow. I'm using a kalmaker'd delco808 ecu.
From what I have researched it pin D11 & D12. On another site I find its D11 only (earth switched) but no mention of the D12 pin!
What s the D12 pin used for ?
Thanks in advance
Greg
H2o injection on delco 808 pinouts
-
- Posts: 24
- Joined: Tue Sep 20, 2011 9:36 pm
- cars: 1965 XP falcon 250 xflow turbo, about to be fuel injected.
- Location: Dalby QLD
Re: H2o injection on delco 808 pinouts
D11 is an input on the 808, D12 is one of the unused outputs. at a guess, its more likely to be D12.
-
- Posts: 24
- Joined: Tue Sep 20, 2011 9:36 pm
- cars: 1965 XP falcon 250 xflow turbo, about to be fuel injected.
- Location: Dalby QLD
Re: H2o injection on delco 808 pinouts
But from what I can find both d11 and d12 are marked h2o
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: H2o injection on delco 808 pinouts
like jayme said D11 is an input, so wont be able to control a relay etc like you want, but D12 is an output which is only used on HSV 6 speed manual, so you would be able to use it for your needs.
but I am guessing you will need some sort of table to setup when it comes on .... might be worth connecting that pin to a relay and a light, go for a drive and see if the light comes on on boost or similar.
but I am guessing you will need some sort of table to setup when it comes on .... might be worth connecting that pin to a relay and a light, go for a drive and see if the light comes on on boost or similar.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread