l67 conversion wiring? ?

[L67siggy]

Hey guys was wondering if anyone could give me a helping hand?
Iv got a vs l67 im doing a conversion and was hoping i could get some help on showing/ telling me what wires need to be used for the fule and pcm relays. Running a vs ecotec pcm with a memcal and ecotec standard loom.
So far iv got:
A8. Main power
B9. To ignition.
A6. Fuel pump relay ground.
Oil pressure switch(violet) to swich for fuel pump relay.
I know there are a few wires more i need but unsure what ones. Any help or advice would be greatly appreciated guys. Cheers in advance.

[The1]

shouldn't be any changes, unless your using L67 fuel pump, in which case you'l need a supercharged PCM. If it's a standard N/A Loom setup just change the memcal and extend the wires for IAC, TPS. If the motor isn't from a VS you'l need to TAP in the extra sensor for temp gauge. If your running T5 box then you'l need a T5 PCM and custom tune.

[L67siggy]

Yeah cheers, iv got all that side done, its the other end, as in pcm relay, fule pump relay im having trouble with.

[The1]

wiring diagrams here might help

http://pcmhacking.net/forums/viewtopic.php?f=32&t=12

[L67siggy]

Cheers again mate, ill have a look at it see where that gets me.