ve bcm reprograming

EPROM EEPROM SRAM NVRAM Flash chips, reading/writing hardware and software
Posts: 112
Joined: Mon Dec 07, 2009 2:14 pm

ve bcm reprograming

Postby jca » Wed May 16, 2018 10:39 pm

hi guys trying to read the epprom on a ve bcm to change the vin data, i have a 8 pin 3m clip and a mini programer but i can get a read off the epprom has any body done it and know the correct eeprom id im using is24c128 chip id , but dosnt read anything

Site Admin
User avatar
Posts: 5296
Joined: Sat Feb 28, 2009 8:34 pm

Re: ve bcm reprograming

Postby antus » Thu May 17, 2018 9:31 am

I havnt tried but if the chip id is right and you cant get any read you might need to desolder the chip and put it in a socket - the bcm might be interfering with the signal. There are not too many so i think removal of the chip would be better than trying to tap the lines on the pcb. Otherwise _maybe_ powering on the bcm would help, but that could also do damage so dont try it unless your prepared to wear the risk.
Attachments
IS24C128.pdf
(53.79 KiB) Downloaded 20 times
Have you read the FAQ? For lots of information and links to significant threads see here: viewtopic.php?f=7&t=1396

Posts: 2326
Joined: Sun Aug 02, 2009 9:16 pm
Location: Bayside, Melbourne, Victoria

Re: ve bcm reprograming

Postby VX L67 Getrag » Thu May 17, 2018 10:09 am

Yeah I had similar issues & using the correct eeprom for the read was key as I had tried hundreds & then eventually lifted the chip to make it easier & still took AGES, but eventually found type...

M93S66

Posts: 112
Joined: Mon Dec 07, 2009 2:14 pm

Re: ve bcm reprograming

Postby jca » Sat May 19, 2018 11:45 pm

Thanks guys no luck yet might have u lift the chip and try it

Return to Chip/Memcal Reading/Writing

Who is online

Users browsing this forum: No registered users and 6 guests