info needed
info needed
Hey just wondering if anyone can tell me wat this bin is?? Does it look any good??
hopefully uploaded properly cheers
hopefully uploaded properly cheers
- Attachments
-
- 2 bar gem original 2.BIN
- (16 KiB) Downloaded 293 times
Re: info needed
memcal id tool tells me $A5 VN V6, looks like asby with ESC disabled and VE, SPark changes mainly.
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: info needed
i haven't had much experience with these 2 bar tunes but from what i understand all the tables will be 100kpa in the middle and 200kpa on the far right column.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: info needed
So no good for 8192 baud tuner pro rt then??
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: info needed
nope!
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: info needed
Okay am new to this n i can't seem to program the chip for the NVRAM, have downloaded the OSE_12P V111 zip folder and still not gettin anywhere. some tips or hints on where to do more reading cheers
Re: info needed
Mate follow the instructions cant go wrong. Set the programer software to ds1245y set off set to 0x08000 (if using dial bin function see instructions for offset)burn the 12p bin you need from the bin folder. After you burn the bin read the nvram save the file open tprt load the 12p xdf and the bin you just saved. Should be all good.
Re: info needed
according to the programmer all is good, put the NVRAM in the car is showing that it is corrupted..
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: info needed
Try burning with 0 offset using the 12P BLCF stacked bin in the zip file. Can flash the cal of your choice in later using TP or the flashtool.
The stacked bin is a 128kb file with two copies of 12P in it, this fills the entire DS1245Y chip and gives you both banks programmed with the correct offsets.
The stacked bin is a 128kb file with two copies of 12P in it, this fills the entire DS1245Y chip and gives you both banks programmed with the correct offsets.
Re: info needed
programmer set ds1245 128k, offset 0, OSE $12P V111 BLCF V8 Stacked.bin. correct?? keeps coming up with errors when programming now. ex error at 0x004e73 chip = 0x15 buffer = 0x00