Pull the DS1245Y off the NVRAM, set the programmer to DS1245Y, read the bin from it. Save it to your PC.
Erase your memcal under a UV light. Set the programmer to 27C010, blank check, if ok burn the bin you saved from the DS1245Y.
Issues writing to DS1245Y from vt to vs
-
- Posts: 80
- Joined: Fri Mar 22, 2013 6:49 pm
- cars: VN s1 V6 Eaton m62 s/c
- Location: South East VICTORIA
Re: Issues writing to DS1245Y from vt to vs
worked a treat VL400 now I cant disable DTC94 m/t vehicle speed sensor failure to get engine light off, it was auto which has been converted to manual, I cand seem to fine DTC94 in my flags using VS V6 v1.24 $51.xdf. it only goes up to DTC 93.
-
- Posts: 80
- Joined: Fri Mar 22, 2013 6:49 pm
- cars: VN s1 V6 Eaton m62 s/c
- Location: South East VICTORIA
Re: Issues writing to DS1245Y from vt to vs
Car is done and a very happy customer, would have not been able to achieve these results without all your support guys, thankyou. So stock vs from 120rwkw to 138rwkw, issue with dtc94 was computer not having a speed signal due to having t5 fitted not getting so had to bypass ecm and go straight to cluster then fudged the rest. Thanks again for all your help.
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: Issues writing to DS1245Y from vt to vs
Good to hear