ve bcm reprograming
ve bcm reprograming
hi guys trying to read the epprom on a ve bcm to change the vin data, i have a 8 pin 3m clip and a mini programer but i can get a read off the epprom has any body done it and know the correct eeprom id im using is24c128 chip id , but dosnt read anything
- antus
- Site Admin
- Posts: 8238
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: ve bcm reprograming
I havnt tried but if the chip id is right and you cant get any read you might need to desolder the chip and put it in a socket - the bcm might be interfering with the signal. There are not too many so i think removal of the chip would be better than trying to tap the lines on the pcb. Otherwise _maybe_ powering on the bcm would help, but that could also do damage so dont try it unless your prepared to wear the risk.
- Attachments
-
- IS24C128.pdf
- (53.79 KiB) Downloaded 307 times
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
-
- Posts: 2877
- Joined: Sun Aug 02, 2009 9:16 pm
- Location: Bayside, Melbourne, Victoria
- Contact:
Re: ve bcm reprograming
Yeah I had similar issues & using the correct eeprom for the read was key as I had tried hundreds & then eventually lifted the chip to make it easier & still took AGES, but eventually found type...
M93S66
M93S66
Re: ve bcm reprograming
Thanks guys no luck yet might have u lift the chip and try it