MEMCAL reprogram VATS removal etc

Want a chip to suit your application? Ask here. Include as much detail in your request as possible.
Posts: 19
Joined: Tue Jan 06, 2015 6:25 pm

MEMCAL reprogram VATS removal etc

Postby robkeith » Fri Mar 26, 2021 10:04 am

Brains trust, help needed.

I need a MEMCAL reprogrammed.

VS V6, 9728 PCM

Application:

Conversion using ecotec motor but memcal needs to be changed to suit,

Loom is from an VS auto but wiring to trans has just been cut at this stage

VSS will be sent to the T5 pin on the PCM plugs (aftermarket vss generator off speedo cable drive, that ran the 808 ECU)
neutral start is already catered for in the existing vehicle wiring

i require the memcal to be reconfigured to suit, listed below is what i think i need to make the car run

1/ NO VATS (no BCM or KEY in the system)
2/ turn OFF auto trans (runs another non compatible auto)
3/ turn OFF fans
4/ turn OFF purge solenoid? (not fitted)

regards

User avatar
Posts: 4456
Joined: Mon Jan 04, 2010 10:23 am

Re: MEMCAL reprogram VATS removal etc

Postby The1 » Fri Mar 26, 2021 10:25 am

So just run a VS V6 T5 Factory code with fan trigger temps high and vats off?

PM me i can do that np or send bin file over.

Posts: 19
Joined: Tue Jan 06, 2015 6:25 pm

Re: MEMCAL reprogram VATS removal etc

Postby robkeith » Tue Mar 30, 2021 5:33 pm

thanks i will

rgds

Return to Wanted

Who is online

Users browsing this forum: No registered users and 2 guests