Brains trust, help needed.
I need a MEMCAL reprogrammed.
VS V6, 9728 PCM
Application:
Conversion using ecotec motor but memcal needs to be changed to suit,
Loom is from an VS auto but wiring to trans has just been cut at this stage
VSS will be sent to the T5 pin on the PCM plugs (aftermarket vss generator off speedo cable drive, that ran the 808 ECU)
neutral start is already catered for in the existing vehicle wiring
i require the memcal to be reconfigured to suit, listed below is what i think i need to make the car run
1/ NO VATS (no BCM or KEY in the system)
2/ turn OFF auto trans (runs another non compatible auto)
3/ turn OFF fans
4/ turn OFF purge solenoid? (not fitted)
regards
MEMCAL reprogram VATS removal etc
Re: MEMCAL reprogram VATS removal etc
So just run a VS V6 T5 Factory code with fan trigger temps high and vats off?
PM me i can do that np or send bin file over.
PM me i can do that np or send bin file over.
Re: MEMCAL reprogram VATS removal etc
thanks i will
rgds
rgds