Hi there, chasing a VR engine loom so I can practice programing a VR ECM. So it will be used for bench testing to start with and then later on, if all goes well, I will convert the loom to run a turbocharged 1915cc VW Superbug.
Also after the ECM plugs to suit the VY computer. That engine is going into a Transit van with a modified loom (Castlemaine Rod Shop). I would like to bench test this ECM as well.
I live in Tasmania.
Cheers
David
VR Engine Loom
-
- Posts: 17
- Joined: Sun Apr 08, 2018 12:38 pm
- cars: Turbod 1972 VW Beetle with very modified suspension and brakes, Transit van getting a VY V6 conversion
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: VR Engine Loom
Vr manual loom is pretty much identical to a vn loom it's just missing the 8192 baud aldl output wire to the diagnostic plug and the speed sensor comes through the floor on vn and up into the engine bay on vr
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
-
- Posts: 17
- Joined: Sun Apr 08, 2018 12:38 pm
- cars: Turbod 1972 VW Beetle with very modified suspension and brakes, Transit van getting a VY V6 conversion
Re: VR Engine Loom
Thanks for that info. Might help me locate a suitable loom.
Cheers
Cheers