vr 355 bin files

nig087 · Post by **nig087** » Sat Jan 15, 2011 10:09 pm

it blows black smoke and smells like fuel

TTVN · Post by **TTVN** » Sat Jan 15, 2011 10:19 pm

try that

TTVN · Post by **TTVN** » Sat Jan 15, 2011 10:26 pm

another a little leaner to try in case lol

TTVN · Post by **TTVN** » Sat Jan 15, 2011 10:33 pm

if they dont give you somewhere to start theres something wrong lol

your going to have to have a go yourself will mainly be in the VE table and may or may not need to pull a bit of timing down low full throttle

are you sure you dont have other problems causing the excess richness like crook map sensor etc

Post by **VL400** » Sun Jan 16, 2011 12:44 am

And are you using a V8 memcal?

nig087 · Post by **nig087** » Sun Jan 16, 2011 1:06 am

yes mate

TTVN · Post by **TTVN** » Sun Jan 16, 2011 8:46 am

also because i bumped the inj flow table to bring the ve back in those tunes the afterstart tables will need modding as it will run rich for a few minutes anyway as the base tune did i just havent got to fixing it yet

will run rich and be cranky till engine starts to warm up a bit

nig087 · Post by **nig087** » Sun Jan 16, 2011 12:58 pm

runs better idles ok but when the fans come on the idle drops off and when i restart it when its warm it won't start unless you have foot on the throttle abit then when it starts runs bad until you rev it sounds like its getting to much fuel

ToyHicko · Post by **ToyHicko** » Sun Jan 16, 2011 1:11 pm

Have to checked to make sure you don't have a leaky injector. As that will make seem to be running rich and make it hard to start warm due to flooding.

nig087 · Post by **nig087** » Sun Jan 16, 2011 2:13 pm

got it running good for now starts idles not rich lowered the afr and inj flow rate

vr 355 bin files

Re: vr 355 bin files

Re: vr 355 bin files

Re: vr 355 bin files

Re: vr 355 bin files

Re: vr 355 bin files

Re: vr 355 bin files

Re: vr 355 bin files

Re: vr 355 bin files

Re: vr 355 bin files

Re: vr 355 bin files