253 V8 carby selection
Re: 253 V8 carby selection
.
Last edited by 'quipt4it on Sat Aug 28, 2021 1:18 am, edited 1 time in total.
- Madmatt2006
- Posts: 369
- Joined: Fri Aug 31, 2018 2:48 pm
- cars: VZ SVZ Commodore
VH Commodore
JZZ30 Soarer GTT - Location: Katandra West
- Contact:
Re: 253 V8 carby selection
You where right about bugger all shaft, I stuffed it right up!
Have you seen the soap/grease method and a snug bolt for pushing the bushing back out? wonder if it works got any other ideas of getting it back out?Re: 253 V8 carby selection
.
Last edited by 'quipt4it on Sat Aug 28, 2021 1:18 am, edited 1 time in total.
- Madmatt2006
- Posts: 369
- Joined: Fri Aug 31, 2018 2:48 pm
- cars: VZ SVZ Commodore
VH Commodore
JZZ30 Soarer GTT - Location: Katandra West
- Contact:
Re: 253 V8 carby selection
Ok I will give it a go fingers crossed. The original was removed with bolt forced threaded and keep screwing works great! takes under 2 minutes
Re: 253 V8 carby selection
.
Last edited by 'quipt4it on Sat Aug 28, 2021 1:18 am, edited 1 time in total.
- Madmatt2006
- Posts: 369
- Joined: Fri Aug 31, 2018 2:48 pm
- cars: VZ SVZ Commodore
VH Commodore
JZZ30 Soarer GTT - Location: Katandra West
- Contact:
Re: 253 V8 carby selection
The grease and bolt method works a treat just make sure the bolt is super snug fit and a normal hammer was shocked how easy
measured it also and will hook box back up and take more photo's
measured it also and will hook box back up and take more photo's
Re: 253 V8 carby selection
.
Last edited by 'quipt4it on Sat Aug 28, 2021 1:18 am, edited 1 time in total.
- Madmatt2006
- Posts: 369
- Joined: Fri Aug 31, 2018 2:48 pm
- cars: VZ SVZ Commodore
VH Commodore
JZZ30 Soarer GTT - Location: Katandra West
- Contact:
Re: 253 V8 carby selection
will do and hook box backup and take some pictures.
Re: 253 V8 carby selection
.
Last edited by 'quipt4it on Sat Aug 28, 2021 1:19 am, edited 1 time in total.
- Madmatt2006
- Posts: 369
- Joined: Fri Aug 31, 2018 2:48 pm
- cars: VZ SVZ Commodore
VH Commodore
JZZ30 Soarer GTT - Location: Katandra West
- Contact:
Re: 253 V8 carby selection
No it's not but I put it in the same way as the old one, I think the chamfer is matched to the input shaft? shaped the same the flat end didn't seem right and it would make it hard to line the box up, but I'm no expert (obliviously)'quipt4it wrote:
Just thinking over that bush again... is the chamfer the same on both ends?
Some more pictures How is that looking? the tape is around the face of the shaft so only the piece that goes in is shown.