Brake pads.
- vlad01
- Posts: 7801
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: Brake pads.
The bracket as in the steel bit that the caliper slides in.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.
-
- Posts: 1833
- Joined: Sat Aug 06, 2011 7:58 am
- cars: V8 VR Commodore BT1
LB Lancer 2L turbo & Delco
Starion TBI with Delco
Mitsubishi Lancer EVO4 track car
NA MX5
3 vintage motor bikes - Location: Padstow NSW
Re: Brake pads.
Ah now I understand. They used a different caliper support bracket with the same caliper as the earlier models to accomodate a larger rotor. . OK on the VL turbo calipers yes they look a tad stronger than the std ones.
- vlad01
- Posts: 7801
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: Brake pads.
Yep!
The difference from 270 to 290 with the stiffer calipers is quite noticeable, but the pads in this case were what I feel 80% of the improvement.
Since I was replacing the rotors anyway, it was a no brainer to go for the 290mm ones.
The difference from 270 to 290 with the stiffer calipers is quite noticeable, but the pads in this case were what I feel 80% of the improvement.
Since I was replacing the rotors anyway, it was a no brainer to go for the 290mm ones.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.
-
- Posts: 1833
- Joined: Sat Aug 06, 2011 7:58 am
- cars: V8 VR Commodore BT1
LB Lancer 2L turbo & Delco
Starion TBI with Delco
Mitsubishi Lancer EVO4 track car
NA MX5
3 vintage motor bikes - Location: Padstow NSW
Re: Brake pads.
Yea the slightly bigger rotor does make a difference in braking power.
- vlad01
- Posts: 7801
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: Brake pads.
First day at work on these pads and lots of traffic on the way in. They are very touchy now and I am having a bit of trouble getting used to them. I tapped the pedal moderately on the Bolte bridge and there was a marking on the lane and slightly damp and I instantly locked up front left lol. They have increased in their responsiveness a lot since I installed them. Currently 3/4 front and 2/3 rear pad contact.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.