BA swap harness questions

Ford information and tools can be found here
Posts: 1
Joined: Thu Oct 04, 2018 11:55 am

BA swap harness questions

Postby Th3cavalry » Thu Oct 04, 2018 2:18 pm

Hey mates!

I'm doing a Barra swap in the US into a 1995 Mustang Cobra.

I'm going to use a factory BA turbo PCM and making a stand-alone harness.

I have a few questions.

1) Is there a place I can purchase the empty A-B-C PCM connectors and where can I also find the PINs?

2) The PCM is an auto and will be using a manual body TH400. I am buying PCMTech and my tuner uses HP Tuners. What settings will I need to change to run as a stand-alone.

3) Is there a list of what components and sensors are needed? I understand know the basics. Injectors, coils, trigger, the VCT, oil pressure and stuff. Is there anything that's out of the ordinary?

Thanks!

User avatar
Posts: 385
Joined: Wed Sep 07, 2016 11:22 am

Re: BA swap harness questions

Postby rolls » Mon Oct 15, 2018 11:03 am

Th3cavalry wrote:2) The PCM is an auto and will be using a manual body TH400. I am buying PCMTech and my tuner uses HP Tuners. What settings will I need to change to run as a stand-alone.
!


Jump on our forums and have a read about the settings you need to modify. Setting up a manual standalone PCM isn't too hard, but you'll need to wire in a speed sensor. You could go to someone like one of these two guys and have them make up the loom and everything you need. If you don't plan on tuning the car it might be cheaper to just get these guys to do everything for you. If you want to tune it I'd still consider getting a loom built by Killa who has done many of them before. They can supply everything you need to fit the new speed sensor as well.

Brett Hogno at Custom Machine Works in QLD (PCM mail service for engine swaps)

https://www.facebook.com/Custom-Machine ... 001022313/

Killa Kustom Kables & Conversions in QLD (Looms for conversion)

https://www.facebook.com/Killa-Kustom-K ... 769825285/

Forums
https://forum.pcmtec.com

Parameters to make the PCM standalone
https://forum.pcmtec.com/index.php?/top ... rce-setup/

Return to Ford ECUs

Who is online

Users browsing this forum: No registered users and 1 guest