OS 12593058 P59 XDF File (INTEL CHIP ONLY!!!)

[Phoenix Profile]

I developed this XDF based on the 7603 file that is on here. Feel free to use and give feedback for anything that may need to be touched up. This is a collection of work from many people, so I cannot take complete credit.

!!! FOR USE ONLY ON 2003 P59 EQUIPPED WITH THE INTEL CHIP !!!

[Gampy]

This NOT an Intel only OS ... It supports AMD as well!

-Enjoy

[bobcratchet555 Profile]

universal patcher and this XDF disagree about the location of vats and vtd config. not sure which is correct.

Thanks

[bobcratchet555 Profile]

also figured i would say THANK YOU to the op for working on all of these XDF files, it has been a big help.

[Phoenix Profile]

universal patcher and this XDF disagree about the location of vats and vtd config. not sure which is correct.

Thanks

It's very possible that I got it wrong. I'll double check later.

[bobcratchet555 Profile]

thanks, I also posted in the universal patcher thread on gearhead-efi

Universal patcher is confusing on this one, as the drop down for VTD_Configuration has two options "0:Class 2" and "1:None" but then the help text says

"VTD_Configuration
This is used to activate the different VTD functionalities within the PCM., Units: Unitless
Controls whether or not a vehicle theft deterrent system is present, and if the fuel will be cut off when the proper parameters are not met to allow the vehicle to start. 0 = VTD signal revieved via class 2 comm., 1 = VTD signal recieved via pulsewidth modulated signal, 2 = No VTD present.
Current value: 2 (Out of range) [02] [ Min: 0 Max: 1] "

So.....which is it?

I will say that, if i set it to 1 in universal patcher it shows up as 1 in tunerpro using this XDF.

[bobcratchet555 Profile]

response on gearhead efi from @joukoy

(sorry, i should've tried to get it all done here)

"This is one issue, that bring confusion alot.
Hope it gets cleared once and for all.

There is 2 type of settings. First settings is for 512kb bins. It got 3 settings 0=class2,1=PWM,2=NONE.
The other type is for 1mb bins and 512kb flex fuel bins. It got 2 settings 0=class2,1=None

Most people just copy over settings from commercial software, and apply the 3 settings types to all xdfs, not aware they are not used on all bins.

If you have bin that shows out of range, just set it appropriate to the bin."