Help understanding BLM scaler tables

For questions relating to the configuration and use of tunerpro
Post Reply
VTXU8
Posts: 93
Joined: Sun Dec 17, 2017 9:12 pm

Help understanding BLM scaler tables

Post by VTXU8 »

Been sorting out fueling and doing some logs. I have turned off Lean Cruise and I have been told to turn off closed loop by adjusting scale temps to 150 degs.
But looking at the BLM scalers it looks to me I should be setting them the other way (lower temp).
BLM.jpg
BLM.jpg (36.77 KiB) Viewed 2880 times
So looking at the 2 tables:
"BLM low coolant temp cutoff" =85.25 degC
"BLM high coolant temp cutoff" = 110 degC

Closed loop will only activate between 85.25 C to 110 C. Anything below low temp cutoff and above high temp cutoff, Closed Loop will not be active?
So shouldn't I set "BLM Low temp" to say 0 degC and the same for BLM High temp"?

I'm a little confused and want to do this correctly.
Using The 1's $A6E enhanced
brindo
Posts: 199
Joined: Mon Jun 29, 2009 9:43 am
Location: Western Queensland

Re: Help understanding BLM scaler tables

Post by brindo »

I guess setting both the low and the high temps to zero would have the same effect as setting them both to 150.

Basically just want it disabled if running some logs so the pcm isn’t trying to adjust your injector table, then put the temps back to normal once your done.
VTXU8
Posts: 93
Joined: Sun Dec 17, 2017 9:12 pm

Re: Help understanding BLM scaler tables

Post by VTXU8 »

Thanks mate
Post Reply