Help understanding BLM scaler tables
3 posts
• Page 1 of 1
Help understanding BLM scaler tables
Been sorting out fueling and doing some logs. I have turned off Lean Cruise and I have been told to turn off closed loop by adjusting scale temps to 150 degs.
But looking at the BLM scalers it looks to me I should be setting them the other way (lower temp).
So looking at the 2 tables:
"BLM low coolant temp cutoff" =85.25 degC
"BLM high coolant temp cutoff" = 110 degC
Closed loop will only activate between 85.25 C to 110 C. Anything below low temp cutoff and above high temp cutoff, Closed Loop will not be active?
So shouldn't I set "BLM Low temp" to say 0 degC and the same for BLM High temp"?
I'm a little confused and want to do this correctly.
Using The 1's $A6E enhanced
But looking at the BLM scalers it looks to me I should be setting them the other way (lower temp).
So looking at the 2 tables:
"BLM low coolant temp cutoff" =85.25 degC
"BLM high coolant temp cutoff" = 110 degC
Closed loop will only activate between 85.25 C to 110 C. Anything below low temp cutoff and above high temp cutoff, Closed Loop will not be active?
So shouldn't I set "BLM Low temp" to say 0 degC and the same for BLM High temp"?
I'm a little confused and want to do this correctly.
Using The 1's $A6E enhanced
Re: Help understanding BLM scaler tables
I guess setting both the low and the high temps to zero would have the same effect as setting them both to 150.
Basically just want it disabled if running some logs so the pcm isn’t trying to adjust your injector table, then put the temps back to normal once your done.
Basically just want it disabled if running some logs so the pcm isn’t trying to adjust your injector table, then put the temps back to normal once your done.
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest