VT $A6 Holden V8 Definition Info

[yoda69]

Nice work

yoda69

[jca]

Hi, Just woundering if any one has finished a version d xdf i need to edit a cfzd bin file.thanks

[VX L67 Getrag]

I don't think there is a version d & that is a version c file, but I'll take it in pm!

[VX L67 Getrag]

Hey all,

Well I had a look & identified a few things that were needed & experts have a look & if it's o.k. can be version 1.4?

I've been trying to figure out for a while what the 2 types of malf/masks are for & correct me if I'm wrong but is the first lot for malf's & if it log's here the PCM will take a different strategy & the 2nd lot are just to mask the engine light?
& I think the 1st lot when set is active for the pcm strategy & the 2nd lot you need to set in active for the check light?

Basically I think all I added was some knock settings, base inj flow rate, idle flow delta & some malf/mask flags!

Cheers VXL67 Getrag

[js1973]

Are the vats addresses in these vt xdf's right.
I am going on the assumption 4b should be changed to 43 in hex or is that not always the case.
I see it is always close to the address in the xdfs

[antus]

Yeah the code is an evolution. For the most part they are similar in order, but things are added and removed. Some things are changed and some arnt. I cant tell you exactly which bit needs to be flipped off the top of my head, but the logic about 'nearby' is usually correct.

[js1973]

Ok so nobody has tested it.
With the t5 option flag would that be correct that it is address 3019 and that in the picture that is set for a t5 with the N

[The1]

what bin your using?

[js1973]

drrr

[The1]

try the one at the bottom here.
https://pcmhacking.net/forums/viewtopi ... t=5#p15043