$12P Custom Tunes

Holden/Delco Tuning. ALDL, OBD 1.5. Circa 1989 to 2004.
Wade
Posts: 562
Joined: Mon Jul 11, 2016 6:29 am
cars: Vr 5.0 statesman vr exec 5.0 turbo vy clubsport

Re: $12P Custom Tunes

Post by Wade »

thought id post this one up too. not really a custom tune, just copied the vs hsv 185kw bin onto 12p with very mild changes here and there and stacked it for a 512 eprom as its going into an 808 ecu
Attachments
Aaron Sparrow.BIN
(64 KiB) Downloaded 746 times
Wade
Posts: 562
Joined: Mon Jul 11, 2016 6:29 am
cars: Vr 5.0 statesman vr exec 5.0 turbo vy clubsport

Re: $12P Custom Tunes

Post by Wade »

vq caprice base tune. car runs strong
Attachments
304 map vt roller twin ex-corvette servo-std diff.BIN
(64 KiB) Downloaded 654 times
K1ng0011
Posts: 69
Joined: Sat Nov 25, 2017 8:13 pm
cars: 1972 Camaro Base Model

Re: $12P Custom Tunes

Post by K1ng0011 »

Basic rebuilt chevy 350 engine, stock lower end, small hydraulic flat tappet cam, poor flowing cylinder heads from the 70s, long tube headers, manual trans, Spartan Lambda Controller 2 wideband o2/controller. This bin is not the stacked .bin for the nvram. This is the one for burning chips. Its been running good with no issues for me.
350TPI Manual Trans 12p v112.BIN
(32 KiB) Downloaded 658 times
DixiePicker
Posts: 16
Joined: Wed Nov 23, 2011 7:32 am
Location: SE USA

Re: $12P Custom Tunes

Post by DixiePicker »

File Name:
Feb 8 2020-Z 454 .BIN
(32 KiB) Downloaded 494 times
[/b] updated
Code Version: $12P V1.12
Engine-Gearbox Type: 454 cu in / 7.4L Mark 4 Big Block - 4L80-E 5.7L Converter GM 16196390 TCM
Mods / Injectors / Description:
1227165 ECM / TunerPro with Moates APU1 and external ALDL for data...
54mm 2x bore T Body - GM/Arizona Speed and Marine Oval Port intake - 39 lb/hr Delco injectors
AC Delco US Coolant Sensor - EP381 Fuel Pump - Small Diameter US HEI Distributor - external coil
Milled Iron Oval Port heads, back cut intake valves, cleaned up bowls in/ex
Camshaft – Flat tappet. In .527” lift ex .552” lift. Dur 302/304
Flat top pistons. Block decked, cast crank, 2 bolt main CR 10.5
Speed Signals=DRAC Module - Speedometer, TCM OSS, ECM VSS, Electronic Speedo, Crz Cntrl, Spd Cntrl Vol Radio
Functioning Delco External ECS Knock system / OEM SS Cast manifolds 2.5” dual Ex
Denso heated O2, Innovate WB. ECM-TCM shared signals. Grds common ECM-TCM-WB
Runs rich at part & WOT. Base timing @ 10 *btdc. In Process. Bin has mods for serial data. Delete CTS Volts, ALDL CTS Volts Byte used for Manifold Fuel RAM Address
Modified ADX has additional Mode 4 commands. Added Dashboards. "Listen for Silence" reduced from 50ms to 5ms Work in progress ((ADX has CTS Voltage delete, Manifold Fuel in place of CTS V.))
Dec 30-Z 2019 Petrol calcVE Man Fuel .adx
(114.69 KiB) Downloaded 509 times
Updated Bin Feb 8, 2020
Vrv8hz
Posts: 21
Joined: Fri Oct 06, 2017 4:33 am

Re: $12P Custom Tunes

Post by Vrv8hz »

File Name: Prem2022.bin
Code Version: $12P
Engine-Gearbox Type: VR 304 V8/TH400.
Mods: Headstuds, LT1 valve springs
Turbo - Borg Warner S366.
3.5" dump to 3" exhaust, 2 mufflers, screamer pipe
FMIC, 3 bar map,
Injectors: 80lb. stock fuel pressure reg 30psi ish base.
Description: , it should work with auto or manual provided its the hydraulic auto.
Running on 98 octane fuel.
350hp at wheels on dyno on 38 degree day in Broome.
Daily driven.
Might be a helpful starting point for someone wanting to do a turbo tune.
Attachments
Prem2022.bin
(32 KiB) Downloaded 253 times
User avatar
Vaxx
Posts: 17
Joined: Thu Mar 24, 2022 6:29 pm
cars: 1985 L60 Diahatsu Handivan running Ecotech and 5 speed
2002 Custom Hilux running 302w and manualised BTR with vn ecu
Location: Gold Coast, Queensland

Re: $12P Custom Tunes

Post by Vaxx »

Here's a challenge for someone :D
Anyone have a bin file for a stock windsor 5.0l on a 808? Would be highly appreciated .
Dylan
Posts: 3355
Joined: Mon Aug 02, 2010 6:35 pm
cars: VR Commodore V8

Re: $12P Custom Tunes

Post by Dylan »

It's actually been done believe it or not.
A stock Holden file would be a pretty good starting point.
Just change to suit your injectors and ignition angle to suit your distributor signal and I'd think it would run.
User avatar
Vaxx
Posts: 17
Joined: Thu Mar 24, 2022 6:29 pm
cars: 1985 L60 Diahatsu Handivan running Ecotech and 5 speed
2002 Custom Hilux running 302w and manualised BTR with vn ecu
Location: Gold Coast, Queensland

Re: $12P Custom Tunes

Post by Vaxx »

Well I was running a ASBX just to get it running reasonable. Was hard to get timing right without pining.
I studied a few 5.0 mustang spark maps and have ended up with this $12p bin. Not too shabby, just a PITA until it warms up, so need to sort that. Leaning towards the water temp sensor where it is fitted on the windsor and me running an electric pump so the water flow through the heater lines is pretty much
f/all. Prob read better and help the cold running if it's fitted in a better flow area :hmm:


any suggestions are welcome
Attachments
leanv8.bin
Windsor with individual throttle bodies
(64 KiB) Downloaded 214 times
User avatar
vlad01
Posts: 7780
Joined: Mon Oct 08, 2012 6:41 pm
cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive
Location: Kyneton, Vic

Re: $12P Custom Tunes

Post by vlad01 »

Yeah you want the CTS right before the thermostat where the bypass coolant flows in, this is the spot where the core engine temp is most accurate and fastest to condition changes.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.
User avatar
Vaxx
Posts: 17
Joined: Thu Mar 24, 2022 6:29 pm
cars: 1985 L60 Diahatsu Handivan running Ecotech and 5 speed
2002 Custom Hilux running 302w and manualised BTR with vn ecu
Location: Gold Coast, Queensland

Re: $12P Custom Tunes

Post by Vaxx »

Well this is where I've ended up so far with it all running pretty well. Still need to get some live data to see if all my changes are doing what I want.
Attachments
WLEAN5.BIN
(32 KiB) Downloaded 204 times
Post Reply