lost in space
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: lost in space
not exactly sure what your asking here, you have an engine loom and you want to know how to wire it in ?
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: lost in space
gidday 202T,
I have nothing, NO loom / plug etc, ..... believe it or not, I seem to be struggling to find an engine to ecu loom VN / VP . One i found was stupidly over priced ( my opinion )
so thinking if it's only 10 - 12 wires, might do one myself
I have nothing, NO loom / plug etc, ..... believe it or not, I seem to be struggling to find an engine to ecu loom VN / VP . One i found was stupidly over priced ( my opinion )
so thinking if it's only 10 - 12 wires, might do one myself
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: lost in space
well theres a 24 pin and a 32 pin plug on an 808, and you probably need at least 3/4 of those pins in use, so I would say its cheaper and easier to get a loom!
eg. http://www.ebay.com.au/itm/272419253850
I have purchased complete commodores with running motors for $200 so I'm sure there is the right bargain out there if you look hard enough.
eg. http://www.ebay.com.au/itm/272419253850
I have purchased complete commodores with running motors for $200 so I'm sure there is the right bargain out there if you look hard enough.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread