Tmap on ecotec
-
- Posts: 13
- Joined: Sat Jun 11, 2016 10:29 pm
- cars: VT Calais L67
Tmap on ecotec
Hello I was wondering if anyone could point me in the right direction to get a tmap sensor working on the ecotec I am struggling to figure out the arguments and equations for tuner pro, I don't care if it does anything with the tune I just want to be able to log it thanks In advance
- Attachments
-
- Pinnout
- pinnout.PNG (48.04 KiB) Viewed 1328 times
-
- Map pressure
- map.PNG (33.6 KiB) Viewed 1328 times
-
- Air temp
- AIRTEMP.PNG (43.83 KiB) Viewed 1328 times
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Tmap on ecotec
in the past when I wanted to log a map sensor on a ecotec I put it on the injector voltage line monitor .....
you can run The1's enhanced bins now days and use one of the 0-5volt inputs.... then just get ground and reference voltage from another sensor.
you can run The1's enhanced bins now days and use one of the 0-5volt inputs.... then just get ground and reference voltage from another sensor.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread