Linking e38 to ve
- Antwon
- Posts: 101
- Joined: Mon Aug 24, 2015 1:14 pm
- cars: vx ss. 80 series daily, vk ls1 (project)
- Location: arcadia vale nsw
Linking e38 to ve
Hi have a ve as the ecu pooped it self so replaced it with a new one and used the tech2 to program it with sps. I went to link it to the car ive got the security code just trying to figure out the linking side of it as when I go on the tech2 engine> programming> program immobiliser function. I get an error and says it failed is there a step I'm missing or do I have to link them a different way cheers
Re: Linking e38 to ve
When you say you replaced it with a new one do you mean 'brand new'? If not the old vin is probably causing your error. Check all related modules for dtc's, that will point you in the right direction.
According to chemistry, alcohol is a solution...
- Antwon
- Posts: 101
- Joined: Mon Aug 24, 2015 1:14 pm
- cars: vx ss. 80 series daily, vk ls1 (project)
- Location: arcadia vale nsw
Re: Linking e38 to ve
Yer brand new one from Holden programmed it with lastest firmware vin matches car the only dtc in t was to do with the ecu not linked to the car but there is a message on the dash saying engine immobilised
- Antwon
- Posts: 101
- Joined: Mon Aug 24, 2015 1:14 pm
- cars: vx ss. 80 series daily, vk ls1 (project)
- Location: arcadia vale nsw
Re: Linking e38 to ve
fixed the issue, it was in the key fob everything worked fine once it was replaced and programmed in.