Vy flash
-
- Posts: 130
- Joined: Tue Nov 29, 2016 2:59 pm
- cars: bf xr6 turbo
vs ss
vr clubsport - Location: Rockhampton
Vy flash
Hi all, is it possible to flash a vy v6 pcm out of the vehicle, and if so what do I need to set it up? I have been asked if I’m able to disable vats for a conversion. Is is as simple as power/earth/aldl enable wires?
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Vy flash
you'll need constant power and ignition power plus grounds, and you'll need the wires for the aldl plug also and i think that should be all you need.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
-
- Posts: 130
- Joined: Tue Nov 29, 2016 2:59 pm
- cars: bf xr6 turbo
vs ss
vr clubsport - Location: Rockhampton
Re: Vy flash
Awesome. Thanks mate. I was hoping that’s all that’ll be required.
- oldn64
- Posts: 256
- Joined: Mon May 28, 2018 5:05 pm
- cars: Vq Statesman, VE SS wagon, VE Sv6, VY SV8, VL Belina
- Location: Country Victoria on a direct road to WINTON
Re: Vy flash
Obviously you will need PC, tuning software and aldl cable interface as well.nutbag355 wrote:Awesome. Thanks mate. I was hoping that’s all that’ll be required.
Tell us more about the conversion too. we are all car nuts after all!!
cheers
oldn64
Re: Vy flash
Whos the best to get the hardware required to do this sort of thing.
- oldn64
- Posts: 256
- Joined: Mon May 28, 2018 5:05 pm
- cars: Vq Statesman, VE SS wagon, VE Sv6, VY SV8, VL Belina
- Location: Country Victoria on a direct road to WINTON
Re: Vy flash
Welcome aboard efid,efid wrote:Whos the best to get the hardware required to do this sort of thing.
all of the things can be sourced through the website here.
What are you hoping to do and with what?
Cheers
oldn64
Re: Vy flash
Adding it to the current vehicles I can tune as I run a dyno and have need to fill a hole. Havent searched much before as I have had enough to do but now just looking at expanding a bit more.
-
- Posts: 130
- Joined: Tue Nov 29, 2016 2:59 pm
- cars: bf xr6 turbo
vs ss
vr clubsport - Location: Rockhampton
Re: Vy flash
Hey mate, not sure on the conversion but can find outoldn64 wrote:Obviously you will need PC, tuning software and aldl cable interface as well.nutbag355 wrote:Awesome. Thanks mate. I was hoping that’s all that’ll be required.
Tell us more about the conversion too. we are all car nuts after all!!
cheers
oldn64
And yep, already have all the hardware and software required to preform the task. Will try and keep you posted