Hi everyone,
I'm changing my 4l60e in my VR SS to a turbo 350 , does anyone know of a VSS that will suit to give signal for speedo to work ?
Vss
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Vss
i looked into this a while back, and i cant remember which one it was, but one of the models had a large VSS that looked like it would go straight into the side of a T350, then you'd just need to swap out the chopper wheels on the output shaft.
BUT i never did it so dont know for sure if it will work.
BUT i never did it so dont know for sure if it will work.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Vss
Im doing an LS conversion ATM that has a turbo 400 in a HQ, I am looking for something similar.
According to chemistry, alcohol is a solution...
Re: Vss
I thought the VN style VSS screwed straight on to the GM "bullet" that houses the speedo gear, guess it must be a different sized thread?
edit: oops, you're looking for a later reluctor style setup, sorry
edit: oops, you're looking for a later reluctor style setup, sorry
Re: Vss
And a pass through that will allow the stock speedo to work
According to chemistry, alcohol is a solution...
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Vss
its going to be a different one for the pass through ....
my theory was this ..... with the box I had was the following:
remove it and install this:
and press this onto the shaft:
now I have done similar in the Bedford, its got a VR computer and T700 hydraulic box, so I put a 4l60e extension housing on it and the speed sensor ring and its done, the question will be if the T350 speed sensor hole is the same, if it is I would suggest it will work, you cant use the whole extension housing though as the length is different to a T350.
unfortunately I never got to trying it out before I sold the LS1 & gearbox and went turbo 202
my theory was this ..... with the box I had was the following:
remove it and install this:
and press this onto the shaft:
now I have done similar in the Bedford, its got a VR computer and T700 hydraulic box, so I put a 4l60e extension housing on it and the speed sensor ring and its done, the question will be if the T350 speed sensor hole is the same, if it is I would suggest it will work, you cant use the whole extension housing though as the length is different to a T350.
unfortunately I never got to trying it out before I sold the LS1 & gearbox and went turbo 202
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread