Wideband setup
Wideband setup
Ive added a 14point7 wideband kit to my 11p ecm and wired it to d8 input. Besides setting the values and ve table is there anything else i need to do to activate it in the ecu?
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Wideband setup
when you say activate it are you referring to just having it reading in the logs ? if that's the case you just need to set the 0v and 5v settings in the calibration, and make sure the calculation for it is right in the adx.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Wideband setup
all sorted i had to remove pull up resistor and calibrate sensor correctly
- vlad01
- Posts: 7801
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: Wideband setup
there is a sequencer on the 14point7 sensors. They go 10, 13.3, 16.66 and 20 on start up. I use that to calibrate the 0v and 5V setting. Mine ended up at 10 on the 0v and 20.3 on the 5v. I have the pull up resistor still in place though but I managed to get perfect calibration.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.
Re: Wideband setup
On the 424 you need to remove it or you won't get any readings. A little different to the 808.