vt 5.0 pcm nvram
vt 5.0 pcm nvram
alright guys, i have just put a vt 5.0 in a vk i have a nvram and aldl from this site. ive downloaded tunerpro rt and followed the installation as described on this site also. i can get tunerpro rt to read the original memcal fine but soon as I plug the nvram in and change the settings to allow for it tunerpro rt just flat out doesn't read it. is there something Im missing? been stuck for a couple of days now with no progress..... it did connect hardware once but the battery fell out of my laptop (face palm) but knowing what I know now Im kinda thinking it wasnt actually conectected and maybe just a glitch because now it does nothing when trying to connect hardware or DA conection PLEASE HELP!!!!!
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: vt 5.0 pcm nvram
What software did you get the nvram loaded with when you bought it was it sent setup for vt v8.
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
Re: vt 5.0 pcm nvram
Yeah when I got it through Gareth he loaded it with the vt software. Is there a way of Telling?
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: vt 5.0 pcm nvram
use the OSE flashtool to connect to it, that should be able to ID what program is on it.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: vt 5.0 pcm nvram
Through the vehicle pcm? It doesn’t pick it it up at all? It will read the memcal fine but when I swap to the nvram (after changing the settings as described) it just comes up with OSEplugin connection problem
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: vt 5.0 pcm nvram
Flick the rs232 echo setting in the plugin
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
Re: vt 5.0 pcm nvram
i have tried that. have gone through the settings 100 differant ways on 2 seperate laptops.
Re: vt 5.0 pcm nvram
should the engine run with the nvram in straight out the bag? i have just managed to get the engine to run with the memcal for about 2 seconds then im assuming vats are kicking in and killing it. but plug the nvram in and it has nothing doesn't even attempt to fire
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: vt 5.0 pcm nvram
You have to fully power off the ecu unplug the battery swap the nvram in then put the battery back on. It sounds like the nvram might be corrupted though
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
Re: vt 5.0 pcm nvram
Ok I’ll suss that out first thing tomorrow. Where do I go from here if the nvram is corrupt?