Looking for a starter map, Kalmaker to $12P

['quipt4it]

All the tip-in stuff is for manual trans.

[vlad01]

So what’s the map actually telling me?
Is it saying at 20% throttle at 1200rpm it’s going to knock 10.55 degrees of timing out?

Pretty much, during sudden throttle movements though. It will feed the timing back in once the throttle stabilizes.

['quipt4it]

From the FAQ
Q. What is "Tip in bump spark"?
A. Tip in bump spark is for low speed drivability in a manual, between tip in bump spark and RDSC (RPM derivative spark control) it adjusts the spark to smooth throttle transitions so you you can cruise the carpark in comfort.

Knew I saw it somewhere!

[Mr DOHC]

I went in to the RDSC stuff and I changed the high and low to 400rpm each so it won’t come on at all.

I should probably change that map to all zeroes too?

['quipt4it]

I went in to the RDSC stuff and I changed the high and low to 400rpm each so it won’t come on at all.

I should probably change that map to all zeroes too?

Just uncheck the Map A: set=RPM derivative spark control option

[delcowizzid]

I wouldn't bother copying anything over just start from scratch set the bpc add your Injector data and start tuning from the 12p basemap

[antus]

Someone used the FAQ, yay!

[Mr DOHC]

Update: i uploaded the bin, this is the first attempt to change my Kalmaker tune to $12P. After the upload, the fan kicked on at full speed and it wont start.
It also wont reconnect to the laptop now.

any ideas on what i fucked up?

[delcowizzid]

You can't just upload 12p to a kalmaker nvram setup you have to put 12p on the nvram with an eprom programmer first then you can upload to it from there

[Mr DOHC]

I've asked that question a few different ways, how do i actually upload, and have received no answer and i didnt see it anywhere else. i assumed that the Kalmaker has the capability via the existing setup.
Any idea on how to change it back?