VX L67 Series 1 - PCM or Com Problems?
- antus
- Site Admin
- Posts: 8239
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: VX L67 Series 1 - PCM or Com Problems?
if you are going to use the nvram, you might as well install oseplugin and get that configured now. choose the car type and that'll handle the chatter, and make sure echo is selected in the oseplugin settings too. that'll take a few potential problems out of the picture and bring you closer to the tuning part when you get the hardware right.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
Re: VX L67 Series 1 - PCM or Com Problems?
As an update I've also installed a new CAS, since I had one or two occasions when the car would crank but not fire. The occasional miss seems to have gone now. Also have a new starter motor and it fires up a lot quicker. New brake pads & rotor have been a great improvement.
Had to adjust the base injector rate a little but other than that it's been running well and haven't had much time to tune it.
Had to adjust the base injector rate a little but other than that it's been running well and haven't had much time to tune it.