Hi all,
I am having some issues connecting a 424 with ALDL and OBD.
Tunerpro is set up correctly with the right XDF, ADX and a 5lt BIN. Correct comms port etc
Pin C1 and D1 have power, ground is correct. ECU powers up and primes fuel output as expected.
OBD pin 9 goes to C11
OBD pin 5 is ground
OBD pin 6 is D6
OBD pin 16 is acc power.
I have soldered the read write wire as required on the back of ECU board.
PCM and RW jumpers are on.
No matter I try I can't connect with tunerpro.
Any ideas what could be wrong here?
Any advice would be great thanks.
Barbs
HELP PLEASE!! 424 won't connect on OBD
HELP PLEASE!! 424 won't connect on OBD
Last edited by BARBS on Mon Sep 27, 2021 1:12 pm, edited 1 time in total.
Re: 424 won't connect on OBD
I must add this is a new NVRAM with $11p but I did mistakingly put it into a 305 and try connect to it at one stage. Is it likely this has damaged the NVRAM? in any way?
-
- Posts: 2877
- Joined: Sun Aug 02, 2009 9:16 pm
- Location: Bayside, Melbourne, Victoria
- Contact:
Re: HELP PLEASE!! 424 won't connect on OBD
I'm asuming you've read through all of this...
viewtopic.php?f=27&t=3798
There's a plugin you need & other mod's but it sounds like the NVram shouldn't be corrupt if fuel pump is priming & fans aren't staying on.
viewtopic.php?f=27&t=3798
There's a plugin you need & other mod's but it sounds like the NVram shouldn't be corrupt if fuel pump is priming & fans aren't staying on.
- antus
- Site Admin
- Posts: 8237
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: HELP PLEASE!! 424 won't connect on OBD
I'd suggest taking the RW jumper off before you go any further. Get it communicating properly and leave it in the write protected state until you know all your wiring is good and you can link up from tunerpro. Its easy to make a mess of things at this stage while your getting it set up right.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: HELP PLEASE!! 424 won't connect on OBD
i heard that removing the bin switch fixed the issue.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread