Sequential ignition

Holden/Delco Tuning. ALDL, OBD 1.5. Circa 1989 to 2004.
Post Reply
jezza351
Posts: 116
Joined: Fri May 22, 2009 6:49 pm
cars: vr ss comodooree

Sequential ignition

Post by jezza351 »

Hi everyone , I have a 304 running a haltech vms .
I'm looking to change it to sequential coil on plug .

I'm running an msd flying magnet trigger wheel currently through a hi6r box .
I know I can use a vt distributor for cam reference , but could I remove all teeth bar one in the pre vt distributor and reference that for cylinder 1 ?

Cheers guys
immortality
Posts: 3416
Joined: Thu Apr 09, 2009 12:31 pm
cars: VH, VN, VS, VX

Re: Sequential ignition

Post by immortality »

Can't see any reason why not if you are using another signal as your primary timing reference like the MSD trigger wheel.
jezza351
Posts: 116
Joined: Fri May 22, 2009 6:49 pm
cars: vr ss comodooree

Re: Sequential ignition

Post by jezza351 »

I'll give it a go , whats the worst that can happen haha :lol:
User avatar
Holden202T
Posts: 10311
Joined: Sat Feb 28, 2009 9:05 pm
Location: Tenambit, NSW
Contact:

Re: Sequential ignition

Post by Holden202T »

most cam signals only require a single tooth so it should be fine!
Post Reply