Bin Changes

Holden/Delco Tuning. ALDL, OBD 1.5. Circa 1989 to 2004.
Post Reply
Kevspec
Posts: 152
Joined: Wed Jan 23, 2019 12:14 am
cars: Vs 215i grange

Bin Changes

Post by Kevspec »

So i have a weird one here, I have a vr ss manual I am tuning.

Someone had previously burnt a chip as it wasn't factory but car still ran fine. I since fitted a new camshaft exhaust diff etc and also ran fine then it chewed a lobe due to pick up being block.

Since i have fitted another cam and gone to start the car and over fuelling etc checked the bin over and seems to now be different everywhere without me touching stuff. adx etc are all still the same but a lot of data inside the bin has changed dramatically and does not make sense.

i have attached the bin sucked from the car then bin I tweaked and I also have another bin just trying to clean stuff up
Attachments
vr ss.bin
(32 KiB) Downloaded 48 times
Brett VR SS#tweaked.bin
(32 KiB) Downloaded 51 times
Brett VR SS.bin
(32 KiB) Downloaded 50 times
Kevspec
Posts: 152
Joined: Wed Jan 23, 2019 12:14 am
cars: Vs 215i grange

Re: Bin Changes

Post by Kevspec »

ok so i tried to drive the car before and its not happy and anytime i tried to give decent throttle and or rpm it blows the ecu fuse in the bay
VTXU8
Posts: 93
Joined: Sun Dec 17, 2017 9:12 pm

Re: Bin Changes

Post by VTXU8 »

Just my 2 cents.
I'd be checking connections/wiring at the ecu. Check for bent or broken pins. Check wiring at the alternator. Whatever it is, it's shorting or drawing alot of current to blow the fuse. Or could be as simple as a loose ground wire.

Also check 02 wiring harness.
Post Reply