ose $11p loose connection after starting engine

Tuning The Delco In Realtime
Posts: 6
Joined: Thu Dec 22, 2016 3:18 pm

ose $11p loose connection after starting engine

Postby carb52 » Fri Sep 18, 2020 5:27 pm

Hi there I am tuning a VR V8 auto using ose 11p if i connect the flash tool with out the engine running it connects ok and tuner pro5 connects
but if i start the engine it will not connect. I have tried different settings in ose and disabled data wire to bcm but still same result.is there a setting I have missed?

User avatar
Posts: 6682
Joined: Mon Oct 08, 2012 6:41 pm
Location: Kyneton, Vic

Re: ose $11p loose connection after starting engine

Postby vlad01 » Fri Sep 18, 2020 5:48 pm

Probably ignition noise. I had the same issue on a VR v8 ute. I moved the coil to on top of the manifold and it mostly fixed the issue, before that the coil was mounted on the back of the strut tower near the main ECU loom and was interfering.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.

User avatar
Posts: 5314
Joined: Sat Feb 28, 2009 8:38 pm
Location: Wellington NZ

Re: ose $11p loose connection after starting engine

Postby delcowizzid » Sat Sep 19, 2020 5:47 am

Make sure you have resistor spark plugs and good leads for a start then if that doesn't help try a different USB cable
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem

Return to Realtime Delco Tuning

Who is online

Users browsing this forum: No registered users and 3 guests