Injector setting check please

Tuning The Delco In Realtime
Posts: 15
Joined: Tue Feb 20, 2018 7:38 pm

Injector setting check please

Postby mpdaff » Thu Mar 07, 2019 7:12 pm

I will be removing the Haltech Interceptor this weekend & adjusting the 808 to suit the different injectors fitted to the 5L (195 KW Roller Cam from VT Clubsport).
I have the following Injectors installed:
VN GROUP A V8 5.0L
0 280 150 706 (EV1) (Cream Tops)
22.55 LB/HR 231 CC/MIN 170.47 G/MIN 15.9 Ohm 2.5Bar OP

Using the kinjflow calculator, I believe that I should be setting the Map A: Run A/F Fuel param - Displacement inj flow rate (Litres/Grams per sec) to 0.100
My fuel pressure is 3 Bar, so I have calculated to allow for that.

I understand I will also need to adjust the opening voltage or dead time table vs volts to obtain an accurate idle fuel rate.

Would someone mind letting me know if my calculations for the Displacement inj flow rate is correct please.
Also, if anyone happens to have settings or suggested settings for the opening voltage or dead time table vs volts I would be grateful if you would be kind enough to share them.

Many thanks for any & all help.

Posts: 3146
Joined: Mon Aug 02, 2010 6:35 pm

Re: Injector setting check please

Postby Dylan » Thu Mar 07, 2019 8:25 pm

Open the VN group a bin. Use that injector rate and calibration data.

Posts: 15
Joined: Tue Feb 20, 2018 7:38 pm

Re: Injector setting check please

Postby mpdaff » Thu Mar 07, 2019 9:10 pm

Thanks Dylan

Return to Realtime Delco Tuning

Who is online

Users browsing this forum: No registered users and 1 guest