Hey guys im having trouble finding anything about converting from maf to map on the ecotec. I've seen blokes running a map but no information given, is it as simple as wiring it up into the b10 pin and using that instead of the maf input for tuning purposes? I'm guessing not hahha
Note- I've got an nvram with the enhanced factory bin, already got wideband just need to finish wiring it up to the a5 pin. Cheers
Vs maf to map conversion?
-
- Posts: 2
- Joined: Sun Dec 28, 2014 8:15 pm
- cars: Vs commodore ute
Re: Vs maf to map conversion?
For now best way would be to go back to a VR ecu for map.
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Vs maf to map conversion?
yeah its either $12P with an 808 or $11P with 424 and this will control the auto!
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
-
- Posts: 186
- Joined: Fri Jul 09, 2010 10:01 pm
- cars: VY s L67
Haines Hunter - not a car but still a toy
Re: Vs maf to map conversion?
You can go kalmaker but The1's enhanced code for the VS which uses the MAF is very good.
It removes alot of the limitations of the factory code
It removes alot of the limitations of the factory code
Re: Vs maf to map conversion?
Is Kalmaker even available anymore? The1 is working on MAP code but I think it's going on the supercharged code first.0081 wrote:You can go kalmaker but The1's enhanced code for the VS which uses the MAF is very good.
It removes alot of the limitations of the factory code
-
- Posts: 186
- Joined: Fri Jul 09, 2010 10:01 pm
- cars: VY s L67
Haines Hunter - not a car but still a toy
Re: Vs maf to map conversion?
Yep is is but not much support for it.
Yep The1 is doing so map stuff but is not done yet from what i have read.
Whats your motor setup??
Yep The1 is doing so map stuff but is not done yet from what i have read.
Whats your motor setup??
Re: Vs maf to map conversion?
as posted above the easiest way that ive found is to go back to a vr loom and 424 im running one on my vt with a map and it works fine but it depends on your setup as well what it needs to do etc etc
The answer is always... boost!
-
- Posts: 2
- Joined: Sun Dec 28, 2014 8:15 pm
- cars: Vs commodore ute
Re: Vs maf to map conversion?
Cheers for the reply's, I'm just researching a bit, looking at top swapping an l67 and turbo it and drop it in my vs ute, not crazy power just some where around 250rwkw. Hopefully the1 has some major breakthroughs haha