Injector setting check please

Tuning The Delco In Realtime
Post Reply
mpdaff
Posts: 19
Joined: Tue Feb 20, 2018 7:38 pm
cars: VS 5l
80 series Landcruiser with VT HSV 195kw engine

Injector setting check please

Post by mpdaff »

I will be removing the Haltech Interceptor this weekend & adjusting the 808 to suit the different injectors fitted to the 5L (195 KW Roller Cam from VT Clubsport).
I have the following Injectors installed:
VN GROUP A V8 5.0L
0 280 150 706 (EV1) (Cream Tops)
22.55 LB/HR 231 CC/MIN 170.47 G/MIN 15.9 Ohm 2.5Bar OP

Using the kinjflow calculator, I believe that I should be setting the Map A: Run A/F Fuel param - Displacement inj flow rate (Litres/Grams per sec) to 0.100
My fuel pressure is 3 Bar, so I have calculated to allow for that.

I understand I will also need to adjust the opening voltage or dead time table vs volts to obtain an accurate idle fuel rate.

Would someone mind letting me know if my calculations for the Displacement inj flow rate is correct please.
Also, if anyone happens to have settings or suggested settings for the opening voltage or dead time table vs volts I would be grateful if you would be kind enough to share them.

Many thanks for any & all help.
Dylan
Posts: 3355
Joined: Mon Aug 02, 2010 6:35 pm
cars: VR Commodore V8

Re: Injector setting check please

Post by Dylan »

Open the VN group a bin. Use that injector rate and calibration data.
mpdaff
Posts: 19
Joined: Tue Feb 20, 2018 7:38 pm
cars: VS 5l
80 series Landcruiser with VT HSV 195kw engine

Re: Injector setting check please

Post by mpdaff »

Thanks Dylan
Post Reply