Little workshop of horrors
Re: Little workshop of horrors
“Twist and heatshrink”... that’s level 1 million expert wiring right there...
Three other shops could find out why this poor old rodeo didn’t make all the boost...
According to chemistry, alcohol is a solution...
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Little workshop of horrors
what the fuck is that ? just carbon ?
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
-
- Posts: 1833
- Joined: Sat Aug 06, 2011 7:58 am
- cars: V8 VR Commodore BT1
LB Lancer 2L turbo & Delco
Starion TBI with Delco
Mitsubishi Lancer EVO4 track car
NA MX5
3 vintage motor bikes - Location: Padstow NSW
Re: Little workshop of horrors
Strip and twist is an industry standard for some. Add the foam packing (or a thong that was used in my van) and you can fit accessories to any car.
Re: Little workshop of horrors
So this Falcon came in for an alignment today, the poor bloke had one workshop do the repairs and when it wasn’t steering properly got another workshop to look at it only to tell him it needed an alignment...
According to chemistry, alcohol is a solution...
-
- Posts: 591
- Joined: Thu Nov 03, 2011 7:57 pm
- cars: hsv enhanced vs ss
vt xu6
fb holden
toyota landcruiser
vt ss s1 - Location: perth wa
Re: Little workshop of horrors
WTF! The scary part is they are working on people’s cars.
- jenko
- Posts: 450
- Joined: Wed Jan 29, 2014 3:43 pm
- cars: hilux v6
jaguar v12
mitsubishi lancer
fj cruiser
sv 21 camry wagon - Location: Pine mountain .vic
- Contact:
Re: Little workshop of horrors
Not to mention the Quality Hifly tyres
-
- Posts: 1833
- Joined: Sat Aug 06, 2011 7:58 am
- cars: V8 VR Commodore BT1
LB Lancer 2L turbo & Delco
Starion TBI with Delco
Mitsubishi Lancer EVO4 track car
NA MX5
3 vintage motor bikes - Location: Padstow NSW
Re: Little workshop of horrors
I'm looking thinking just how low is this car with the angle of the tie rods then realised. How the hell did they get them to fit? Steering arms on the wrong side as well?
Re: Little workshop of horrors
Ha, ha far out. Mind boggling
- vlad01
- Posts: 7798
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: Little workshop of horrors
Imagine the bump steer on that.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.