I'm new to the E38/E67 binary tinkering (I've mainly done IMMO cloning in the past) and I thank you Daniel for making this tool! It will be a huge help to me I'm sure!
I am having some slight difficulties and I'm curious if anyone else has tried a VCX Nano as the pass through device? I've tried using the provided VCX Nano dll and also the MDI dll's with different results but no success connecting to the ECU.
Here's what happens with the VCX Nano dll (VCXPT32.dll)
Code: Select all
initialising Tool J2534 PassThru
Bosch - MDI...
ok.
connecting...
start periodic CAN NOT ok: 12
Code: Select all
initialising Tool J2534 PassThru
Bosch - MDI...
ok.
connecting...
start diagnostic session (0x10 0x03)...no reply first frame, Read_FF.
no reply.
Any advise/help would be greatly appreciated! Thanks!