GM HMI 2.5 Fault... "waiting for Update Media"
GM HMI 2.5 Fault... "waiting for Update Media"
Good evening. The problem is the following. 2018 Chevrolet Tahoe car. The HMI unit has stopped working. Constantly issues the inscription Waiting for Update Media. And that's it. Nothing canbe done. Diagnostic equipment does not see this unit. Therefore, it cannot be reprogrammed through the techline. Can anyone tell me what are the options to revive it? System GMG3G_LINUX_15.2B033
Re: GM HMI 2.5 Fault... "waiting for Update Media"
GM had a big issue with HMI modules in 2017 and 2018 trucks losing comm and shorting the high speed bus. may need to replace it
-
- Posts: 583
- Joined: Thu Feb 13, 2020 11:32 pm
- cars: Mainly GM trucks, a Cruze and an Equinox for dailys..
Re: GM HMI 2.5 Fault... "waiting for Update Media"
bulletin for that for 16 and 17's, might be able to save it, if the screen disappears after 80 minutes... Would need an HMI update at a minimum..
Re: GM HMI 2.5 Fault... "waiting for Update Media"
Thank you, I saw this bulletin. It doesn`t disappears after 80 minutes. Tried it. It only become black. But you can`t programm it because it. ((( I think only replacing will finish this problem
Re: GM HMI 2.5 Fault... "waiting for Update Media"
When I have dealt with this in the past, there is corrupted files in the memory which result in a permanent boot loop that prevents the HMI from accepting a reflash. Replacement is usually the recommended option that we offered since repair was not guaranteed.Francuzzz wrote:Thank you, I saw this bulletin. It doesn`t disappears after 80 minutes. Tried it. It only become black. But you can`t programm it because it. ((( I think only replacing will finish this problem
Your Local Aussie Reverse Engineer
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
Contact for Software/Hardware development and Reverse Engineering
Site:https://www.envyouscustoms.com
Mob:+61406 140 726
- Gatecrasher
- Posts: 273
- Joined: Sat Apr 25, 2020 6:09 am
Re: GM HMI 2.5 Fault... "waiting for Update Media"
I bought a unit off eBay that had the same problem. I was never able to recover it by any normal means. I just figured the flash memory was corrupt and tossed it in my spare parts bin. I didn't pay much for it to begin with.