VS-VY Enhanced Factory Bins

[immortality]

Yes they are 0-5 volt sensors.

[In-Tech]

Hello,
Are you sure these are 3 wire 0-5v sensor? The output does look linear but it appears to be a thermistor ohm output. I have hunted long and hard for a 0-5 linear output temp sensor.

[immortality]

They are 2 wire same as the factory GM type sensor. On the website linked earlier it has all the info

[lludorf]

Is anyone interested in flex fuel support?

yes please!!!!!!!!

[PHLTHS]

Is anyone interested in flex fuel support?

I am, yes please. It would be awesome to be able to use E85 and have blend tables for timing, fueling, cranking etc.

[encrypted]

Having issues with changing to negative spark in the high and low octane tables for stupid crackle on decel on the vs v6 enhanced bin and xdf when I say set the decel tables to neg-15 and save it then reopen it it’s at 0 not-15 if there a max retard table somewhere im missing that needs to be changed like vx/vy v6 any help is appreciated

[antus]

if you are prepared to take the risk try the xdf for the non-enhanced version *of the same os*. The enhanced are patched, not rebuilds so items that work on the factory OS but are omitted from enhanced are probably still there and likely to work.

[The1]

Having issues with changing to negative spark in the high and low octane tables for stupid crackle on decel on the vs v6 enhanced bin and xdf when I say set the decel tables to neg-15 and save it then reopen it it’s at 0 not-15 if there a max retard table somewhere im missing that needs to be changed like vx/vy v6 any help is appreciated

Unfortunately the factory code starts at 00 Hex as 0 spark. This changed with VT.

You can work around it by using the Extended Intake Air tables to offset the spark into negative down low perhaps as ive codded them to allow negative.

[hsv08]

Has anybody worked out where the address location for DTC92 - Low speed fan communication failure is on the Flash Ecus?

Just to turn that processing off for when running flash pcms in standalone configuration without a bcm?

[The1]

Has anybody worked out where the address location for DTC92 - Low speed fan communication failure is on the Flash Ecus?

Just to turn that processing off for when running flash pcms in standalone configuration without a bcm?

Try these and let me know, if it's good then ill update the main page.