T43 Dissasembly

[gmtech825]

the older gen 3 stuff has a coast mode flag and then a seperate coast mode while braking flag. It might be that simple

[hjtrbo]

I wish

[hjtrbo]

Line pressure calc. There's a few places to adjust if needed. My lifes work lol

[antus]

Good stuff. I like how you are using the code to chart exactly how these things work. There is no shortage of programs that can change things, but knowledge at this depth is rare and very helpful.

[hjtrbo]

Ta, it's far easier to follow a chart I feel. In the future when I forget everything, referencing these charts will jog the memory that much faster than digging through partially labelled dis-jointed disassembly code again!

On a side note, I have a t43 techm sitting in front of me on loan from a very friendly bloke on this forum. I'm not quite ready to start playing with it, but not to far away hopefully. Just want to get this disassembly finished first. I think I have either borderline OCD or autism.

[antus]

Dont we all

[hjtrbo]

And here is an update to the tcc pressure command. For those that use the regulator offset / gain settings, there is a few extra scalars and tables (approx. 7) not in HP or EFILive that can add to the offset. For the circle-d guys it might be worth some of your time investigating those to see if they're useful. Some are gear based too. Unfortunately not all OS's have this adder. I've marked it with a cloud. If you load up my disassembly from page 1, jump to address 0x0015b6cc to see it.

[hjtrbo]

I never would have picked there are so many tcc modes. There are a crap tonne of transition criteria behind each mode which will keep me occupied.

ACbadsn.png (32.83 KiB) Viewed 674 times