I've bought myself a new Delphi 25168491 MAF thought about going card MAF but because i did my intercooler pipes in Stainless the Fab would of been an Absolute Dog! so 14000hz max will have to do.
If anyone can give me some tips on setting one up reply here or PM me....... or just drop a link
Cheers
Shoot me an inbox mate I make a ls7 maf setup same size as factory
Hi,
I have been playing with Lean Cruise AFR in the old 0.9a version, finding I needed to reduce AFR multiplier in the LEAN Cruise Air Fuel delta table above 375 as it would bog down and occasionally end up kicking down. This gained me a little economy. I spotted there is now an v0.10a XDF, although it is does not show the Lean Cruise Air Fuel delta table, although now has Lean Cruise Spark Tables.
Has the Lean Cruise Air Fuel Table moved and where did the Lean Cruise Spark Tables come from ?
My old version
VY_V6_$060A_Enhanced_v0.9i.zip
- VY_V6_$060A_Enhanced_v0.9a.bin
- VY_V6_$060A_Enhanced_v0.9c.adx
- VY_V6_$060A_Enhanced_v0.9i.xdf
Was comparing above to below and a bin, I think it was a 98 octane tune from from Wade's road car
- VY_V6_$060A_Enhanced_v0.10a.xdf
Latest version from Wade's msg sep28 2024:
VY_V6_$060A_Enhanced_v1.2.zip
- VY_V6_$060A_Enhanced_v0.9a.bin
- VY_V6_$060A_Enhanced_v0.9c.adx
- VY_V6_$060A_Enhanced_v0.12a.xdf >>> couldnt see any Lean cruise
*could be me messing up my bins, xdf and adx
Last edited by rallyrs on Sun May 04, 2025 8:51 pm, edited 5 times in total.
sorry, i edited detail in original msg with the details of the 2 versions I was referring to.
I see there is a later VY_V6_$060A_Enhanced_v2.00a.xdf, is that still a beta version ?
Thats the latest xdf but only for the beta version, the version in the OP in this thread use the one bundled with it. Dont use xdf's that arn't bundled with the bin,adx files it will be unknown. If the bundle your using is missing something post here and we might be able to add the table your after.
Someone was trying to fix idle spark issues on VT? Ive found a offset scalar for P/N Idle Spark, -5deg from what i can workout, so if you set it to 0 it should give you the same spark as the idle table. Try it and let me know.
The1 wrote: ↑Mon May 05, 2025 1:18 pm
Someone was trying to fix idle spark issues on VT? Ive found a offset scalar for P/N Idle Spark, -5deg from what i can workout, so if you set it to 0 it should give you the same spark as the idle table. Try it and let me know.
Scalar is called Spark - Idle P/N Spark Offset
Yes this what I been needing thank you will try very soon hopefully it works as intended and then hopefully can be applied to your sc enhanced bins/xdf
